Pages

Monday, December 19, 2011


Here's a fabulous way to keep the kids busy while they wait for holiday festivities or any day of the year!  And, it's a recycling project too!  It uses #6 plastic containers - and things from around your home.
I Shrunk the Plastic

Materials Needed
Cookie cutter, plastic or other plastic item for hanger
Wire or fishing line
#6 clear plastic containers
Plastic decorations: beads, toys, etc
Permanent pens
Scissors
Hole punch, small
Cookie sheet
Oven mitt
Candle
Paperclip
Plastic ring
Glue
1” wide braid
Oven or toaster oven

Directions

Draw design on clear plastic with permanent pens. NOTE: The designs will shrink about 50% of the original size. Cut out. Punch holes in top and bottom. Preheat oven to 300 degrees. Place clear plastic designs on cookie sheet and place in oven until they lay flat. This will only take a few minutes. Remove from oven using oven mitt. With adult supervision, make holes in plastic decorations by heating paperclip in candle flame. Insert into plastic to make holes. Thread beads, shrink plastic designs, toys, etc. on wire, knotting below item to secure. Make holes around bottom of cookie cutter edge with hot paperclip. Thread decorated wire in hole and knot. Repeat for all wires. Make three evenly spaced holes around top of cookie cutter. Cut three 12” pieces of wire. Insert each wire into a hole and knot. Gather wire at top and tie around plastic ring adding a bead, if desired.

No comments:

Post a Comment